S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Transmission Temperature Sensor/Switch: Service and Repair
Cable Harness/Temperature Sensor, Replacing
Cable Harness/Temperature Sensor, Replacing
NOTE: As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the
essential information is always correct.
Preparatory work
Removing components
Remove:
-
the transmission control module (TCM).
-
the control system cover.
Removal
Removing the cable harness
Remove:
-
the connectors for the solenoid valves
-
the screw for the oil temperature sensor holder. Detach the sensor from the control system
-
the cable harness from the holders on the control system
-
the cable harness.
Installation
Checking the seal for the cable harness Check that the seal for the cable harness connector is fault free and in position.
Installing the cable harness for the transmission
Install the cable harness for the transmission. Ensure that the guide for the connector comes between the lugs on the transmission. Ensure that the cable