S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Procedures/Description Of Counter
Description Of Frozen Values, HCM
Description of frozen values
Explanation
Frozen values are parameter values that are stored when a diagnostic trouble code is generated. Not all parameters can be read out for all diagnostic
trouble codes. The parameter values can only be read if they can provide additional information on the prevailing conditions when the code was
generated.
Engine running
The status denotes whether the engine was running or not when the diagnostic trouble code was generated.
Global time
The value displays the time that has passed since the diagnostic trouble code (DTC) was stored.
Passenger compartment temperature, value
Measurement range: -40 till +80 °C
The value indicates the passenger compartment temperature when the diagnostic trouble code was generated.
Outside temperature, value
Measurement range: -40 till +80 °C
The value indicates the outside temperature when the diagnostic trouble code was generated.
MECU power supply, value
Measurement range: 0 - 63 V
Normal range: 12.0 - 14.5 V
The value indicates the power supply to the central electronic module (CEM) when the diagnostic trouble code was generated.
Total mileage
Measurement range: 0-1000000 km.
The value indicates the vehicle's total mileage when the Diagnostic Trouble Code (DTC) was generated.
Pinout Values and Diagnostic Parameters
Signal specification
General
All values below are measured between the relevant terminal in column 1 and terminal #2F in column 2 (power ground). Unless otherwise stated in
parenthesis after the table entry.
Note! It is important to connect the breakout box and check the ground terminals before taking readings.
Connector, headlamp control module (HCM)