S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Installing the occupant weight sensor (OWS)
Install the heating element. Refer to: Front Seat Heater Mat See: Body and Frame/Seats/Seat Heater/Service and Repair/Front Seat Heater Mat
Note! Ensure that the wiring is routed through the holes exactly as illustrated.
Caution! Do not pinch the hose from the silicon pad to the pressure sensor during installation.
Caution! Do not pinch the hose from the silicon pad to the pressure sensor during installation.
Install:
-
the 2 screws. Tighten
-
the connector at the end mounting
-
the connectors on the multi-connector
-
the pressure sensor/silicon cushion on the bracket under the seat. Secure the silicon hose in the clip/holder
-
the pressure sensor/silicon cushion using 2 clips
-
the seat cushion. Fold down and secure the upholstery. Refer to: Front seat cushion See: Body and Frame/Seats/Seat Cushion/Service and
Repair/Front Seat Cushion
-
the battery negative lead. See: See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting
Calibrating the occupant weight sensor (OWS)