S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Remove:
-
the tunnel compartment. See: Floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console
-
the connectors, x2
-
the 4 x screws.
Lift the control module out.
installation
Note! For tightening torques, see Specifications. See: Body and Frame/Specifications
Installing the supplemental restraint system module (SRS)
Caution! Make sure that there are no loose particles or similar between the control module and the body panel. This can cause poor
functionality or over-sensitivity in the SRS system.
Install:
-
the control module
-
the 4 x M6 screws. Tighten
-
the connectors, x2
-
the tunnel compartment. See: Floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console
Finishing
Ordering software
Order software. See: See: Testing and Inspection/Programming and Relearning/Software Downloading
Checking the SRS (supplemental restraint system)