S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Remove:
-
the B-post panel. See: B-pillar trim panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/B-Pillar Trim Panel
-
the connector for the igniter cable (1).
Loosen the screw, 1 pc., for the pyro pipe's (2) pipe clamp.
Remove:
-
the screws (3), 2 pcs., for the belt roller (retractor)
-
the front seat's side panel, see: Side panel front seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat/Side
Panel Front Seat.
Insert a screwdriver on the inside of the end mounting. Remove the seat belt by pressing the catch inwards and pulling upwards.
Lift out the seatbelt roller (retractor) from the pipe clamp.
Installation
Installing the front seat belt.
Lift in the seatbelt roller (retractor) with pyro pipe in the pipe clamp.
Install:
-
the seat belt
-
the side panel as described in Side panel front seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat/Side
Panel Front Seat
-
the screws, 2 pcs. M10 for the belt roller (retractor). Tighten, see: Tightening torque See: Body and Frame/Specifications
-
the screw, 1 pc., st, for the pyro pipe's pipe clamp. Tighten
-
the igniter cable connector
-
the B-post panel. See: B-pillar trim panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/B-Pillar Trim Panel.
Finishing
Checking the function
Check the function of the belt as described in Seat belt function, check See: Testing and Inspection.
Carry out an inspection as described in Supplementary restraint system (SRS), inspection See: Testing and Inspection/Component Tests and General
Diagnostics.