S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
-
Measure on the side panel according to image A or B.
-
Drill out the hole for the 12V socket using a -29 mm (1 1/8") hole saw.
-
Cut out the panel at the rear edge of the hole according to the measurements in the image.
-
Clean around the hole edges.
-
Install the 12V socket in the hole in the panel. Install the space washer and nut, and tighten.
Applies to the S40 (04-) and V50
-
Locate the white 2-pin female connector at the rear edge of the right-hand rear wheel housing.
Applies to the V50
-
Reinstall the insulation panel.
Applies to the S40 (04-) and V50
-
Reinstall the side panel. Connect the white connector to the 12V socket.
Applies to the V50
-
Tighten the screws for the load securing eyelets. Tighten to 24 Nm (18 lbf.ft.).