S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Remove the screw.
Widen the groove. Use: 999 7088 Expander See: Tools and Equipment/999 7088 Expander , install the tool so that the flat sides run along the groove,
and turn 45°.
Carefully tap the wheel spindle downward with a copper mallet so that it releases from the strut assembly.
Installation
Installing the wheel spindle
Note! For tightening torques, see Specifications. See: Specifications
Install
-
tool on the new spindle. Use: 999 7088 Expander See: Tools and Equipment/999 7088 Expander
-
wheel spindle on the shock absorber
-
the screw, 1 pc., to the wheel spindle's attachment on the shock absorber. Tighten according to: Tightening torque See: Specifications.
-
the drive shaft
-
wheel spindle on the ball joint. Use: 999 7076 Lever See: Tools and Equipment/999 7076 Lever to press down the link arm
-
the nut for the ball joint. Use an Allen key as counterhold. Tighten according to: Tightening torque See: Specifications
-
the screw, 1 pc., for the drive shaft. Counterhold on the brake disc by locking it with a screwdriver in the ventilation hole. Tighten according to :
Tightening torque See: Specifications.
Installing the ABS-sensor
Install:
-
the sensor
-
the screw, 1 pc. M5.
Installing the steering arm
Install:
-
the steering arm
-
the M10 nut. Use an Allen key as a counterhold.
Installing the brake shield
Install:
-
brake shield
-
the bolts, 4 pcs. M5.
Installing the brake disc
Install:
-
the brake disc
-
the retaining clip.
Installing the brake caliper
Fit the bolts, x2. Tighten in accordance with: Tightening torque See: Brakes and Traction Control/Specifications/Tightening Torque.
Finishing