S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Disconnect the cable from the end of the gear selector assembly. Pull back the locking sleeve.
Note! Hold as close to the ball joint as possible. Do this by hand.
Route sufficient cable into the passenger compartment that it is possible to work the cable off the ball joint.
Remove the gear selector cable.
Installation
Note! For tightening torques, see Specifications. See: Specifications/Mechanical Specifications/Tightening Torque
Installing the gear selector cable
Tape the gear selector cable in place in the pre-routed cable. Insert the gear selector cable a little way through the hole in the floor.
Hint: Ask someone to pull the gear selector cable to assist you.
Install:
-
the gear selector cable on the end of the gear selector assembly. Press the ball joint into place.
Installing service clips