S40 2.4i L5-2.4L VIN 38 B5244S4 (2008)
Carefully disconnect the four snap fasteners. Lift out the panel.
Caution: When the panel has been removed, a printed circuit board is visible. Do not touch the printed circuit board. Risk of electrostatic discharge.
Installation
Installing the top panel Check that there is no dirt on the printed circuit board. Position the panel. Press the four snap fasteners into place in each
corner.
Finishing
Installing components
Install:
-
the gear selector knob. See: Gear selector knob, replacing
-
the center console. See: Center console, replacing -