S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Angle the dashboard environment panel outwards so that it is possible to insert a couple of fingers between the centre console and the side of the
dashboard environment panel
-
Pull the dashboard environment panel downwards while maintaining the same angle. Remove the dashboard environment panel. Some force is
required because the panel is tightly installed
-
Disconnect the connectors on the reverse of the dashboard environment panel. Put the dashboard environment panel to one side.
Note! If any of the outer hooks break off, these must be repaired. The method for this can be found in the service information in the section
covering the dashboard.
-
Remove the screws (1) from the radio bracket
-
Pull out the bracket with the radio (pull the lower corner while pressing downwards)
-
Disconnect the radio connectors. Remove the bracket with the radio.
Remove:
-
right side panel (1) by turning the screw clip at the rear edge of the panel half a turn. Pull the panel outwards and backwards
-
the sill trim panel (2) at the right front door
-
the covers (3) for the front seat mounting
-
the two screws (4).
