S60 L5-2.4L VIN 64 B5244S6 (2003)
Auxiliary Input / Output Jack: Service and Repair
Part 2
iPod adapter (Continued)
Routing of cable to power supply
For cars up to model year -2004 without RTI
-
Take the iPod adapter power supply cable, P/N 30660440, from the kit.
-
Connect the ground cable to the front grounding point (1) in the rear seat and tighten to 10 Nm (7 lbf.ft.).
-
Route the power supply cable on the right side of the cable duct (2), underneath the cables of such. Then route up along the wheel housing
following the same route as the iPod adapter cable and up to the adapter cable.
Hide excess length of cable under the floor mat on the passenger side.
-
The cable end with the two loose red/white (R/W) wires is routed along existing cables to the rear fuse holder.
Position the cable end with the blue connector at the iPod adapter. Make sure that the cable does not chafe against sharp edges.
-
Clamp in the cable at the existing cable harnesses using three tie straps from the kit.
For cars from model year 2005- without RTI
-
Take the iPod adapter power supply cable, P/N 30660440, from the kit.
-
Route the ground cable along existing cable harnesses towards the stern, along the cable harness there and up to the grounding point behind the
battery.
-
Connect the ground cable (1) to the existing grounding point and tighten to 10 Nm (7 lbf.ft.).
-
Position the red/white (R/W) wires at the rear fuse holder.
Position the cable end with the blue connector at the iPod adapter. Make sure that the cable does not chafe against sharp edges.
-
Clamp in the cable at the existing cable harnesses using three tie straps from the kit.
For cars up to model year -2004 with RTI
