S60 L5-2.4L VIN 64 B5244S6 (2003)
radio.
-
Connect the other connectors to the radio.
-
Plug in the connectors for the phone keypad, if applicable.
-
Reinstall the bracket with the radio and secure it with the screws.
-
Plug in the connectors to the dashboard environment panel. Reinstall the dashboard environment panel.
-
Reinstall the panel in front of the centre gear selector lever.
Applies to cars from model year 2005- (S60 CH 425000-, V70 CH 459000-, XC70 CH 173000-)
-
Connect the grey connector from the amplifier to the grey connector which was detached from the radio.
-
Connect the other connectors to the radio.
-
Plug in the connectors to the dashboard environment panel.
-
Plug in the connectors for the phone keypad, if applicable.
-
Reinstall the unit with radio and dashboard environment panel in the centre console. Tighten with the two screws.
-
Reinstall the panel around the gear selector lever
Applies to all models
-
Reinstall the carpets.
-
Plug in the connectors to the seat and reinstall it.
-
Screw in four new screws to the seat frame, tightening torque 40 Nm (30 lbf.ft.).
-
Reinstall the covers over the seat screws.
-
Reinstall the soundproofing panel.
-
Reinstall the centre console's panels.
-
Reinstall the sill moulding.
Connection and finishing work S80
-
Plug in the connectors for loudspeakers, amplifier and antenna to the radio.
When connecting the grey connector from the amplifier, take the grey connector to the loudspeakers out from the radio. The two connectors are plugged
in to each other. The loudspeaker socket in the radio is not used.
-
Push the radio into its cut-out.
-
Press up the radio so that the groove in the top of the bracket encloses the top edge of the radio cut-out. At the same time, angle the radio down so
that the bracket's lower mountings are pressed against the lower edge of the radio cut-out.
-
Screw in the two screws (1) in the lower mountings and tighten.
-
Reinstall the panel around the gear selector lever
-
Plug in the connectors and reinstall the dashboard environment panel.
-
Reinstall the carpets.
-
Plug in the connectors to the seat and reinstall the seat.
-
Screw in four new screws from the kit to the seat frame, tightening torque 40 Nm (30 lbf.ft.).
-
Reinstall the covers over the seat screws.
-
Reinstall the soundproofing panel.
-
Reinstall the centre console's panel.
-
Reinstall the sill moulding.
Applies to all models
