volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Cable Harness for the Radio (Accessory Electronic Module)|Page 15353 > < Cable Harness for the Radio (Accessory Electronic Module)|Page 15351
Page 5
background image

-

Angle the dashboard environment panel outwards so that it is possible to insert a couple of fingers between the centre console and the side of the
dashboard environment panel

-

Detach the dashboard environment panel by pulling it downwards while maintaining the same angle. Some force is required because the panel is
tightly installed

-

Disconnect the connectors on the reverse of the dashboard environment panel. Place the dashboard environment panel to one side.

Note! If any of the outer hooks break off, these must be repaired. The method for this can be found in the service information in the section
covering the dashboard.

-

Remove the screws (1) from the radio bracket

-

Pull out the bracket. Pull the lower corner while pressing downwards.

Remove:

-

right side panel (1) by turning the screw clip at the rear edge of the panel half a turn. Pull the panel outwards and backwards

-

the sill trim panel (2) at the right front door

-

the covers (3) for the front seat mounting.

Applies to S60 and S80

Cable Harness for the Radio (Accessory Electronic Module)|Page 15353 > < Cable Harness for the Radio (Accessory Electronic Module)|Page 15351