S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Route the cable harness (1) out through the hole in the bodywork at the front edge / top edge of the wheel arch and along the right-hand side of the
rear cable duct (2) to the right tail lamp.
Illustration B applies to the V70
-
Route the cable harness (1) out through the hole in the bodywork at the front edge / lower edge of the wheel arch and along the right-hand side of
the rear cable duct / floor support (2) to the right tail lamp. Lift up the insulation panel for the wheel arch slightly to route the cable harness
between the floor support / cable duct and the wheel arch.
-
Remove the screw (1) from the accessory electronic module lock facing
-
Pull the lock facing out to the right. Remove the lock facing.
