S60 L5-2.4L VIN 64 B5244S6 (2003)
Hint: Two people should assist with drilling the holes and installing the Jukebox and console.
Take the Jukebox console from the kit and position it against the panel under the parcel shelf on the left-hand side as illustrated, hold it still and mark out
the rear hole in the right-hand side of the console.
Note! Do not damage the cables while drilling.Use protective safety goggles if lying in the cargo compartment to drill.
-
Drill the hole using a - 6 mm (15/64") diameter drill bit, and deburr it.
-
Take four M5 screws, washers and nuts from the kit. Install the console with one screw in the drilled hole. Tighten the screw by hand.
-
Align the console so that it is straight.
-
Mark out the three remaining holes. Remove the console.
-
Drill the three remaining holes, deburr them and apply anti-corrosion protection to the edges of the holes.
-
Take the console and spacer washers from the kit and press the washers into the holes in the bottom of the console.
-
Take the Jukebox with the blind rivets and plastic washers from the kit, position it over the spacer washers installed in the console.
