S60 L5-2.4L VIN 64 B5244S6 (2003)
Speaker: Service and Repair
Front Door Bass Loudspeaker Kit
Front door bass loudspeaker kit
Preparations
Note! This accessory is connected to the car's electrical system. It requires software unique to the car. Carry out the operation on both sides.
-
Remove the clips (1) by pressing in the centre of the clips
-
Remove the cover (2) on the door handle. Use a weatherstrip tool. Start at the upper or lower edge
-
Remove the two screws (3) from under the cover
-
Remove the cover for the door mirror by pulling the cover straight out
-
Disconnect the door panel by sliding the panel upwards and unhooking the top edge.
-
Remove the three connectors (1) from the module for the door controls and from the existing loudspeaker
-
Remove the cable (2) from the door opener (3). First bend up the catches
-
Remove the panel
-
Remove the panel (4) for the cable lead-in
-
Drill out the rivets (5) on the existing loudspeaker. Use a -6 mm (1/4") drill bit
-
Remove the loudspeakers and any rivet swarf from the rivet holes. Remove the rivet sections from the door if necessary.
Installation