S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Slacken off the screw (1) almost completely in the rear edge of the wheel arch on the left and right hand sides
-
Press the screw using a screwdriver. This is so that the loose ends on the inside of the bumper cover bend backwards
-
Carefully drill out the rivets (2) underneath the bumper on both sides. Use a Dia. 6 mm (1/4) drill bit. Do not damage any of the plastic
components.
Remove:
-
the perforated sections of the insulation panel (1) and the nuts (2) for the bumper in the rear cross member
-
the antenna connector (3)
-
the rubber seal (4) covering the hole over the antenna connector. Save the seal as it will be used to lead-in the cable harness for the sensors in the
existing hole.