S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Connect the black/yellow (SB/Y) cable to position H in the black (SB) 12-pin connector.
-
Move the locking mechanism back to locked position.
-
Insulate the cable terminal on the unused blue/yellow (BL/Y) cable and secure the cable to the cable harness. If neither cable is intended for
connection, insulate and secure both cables.
Illustration A
-
Route the cable harness from the tow bar connector through the hole in the floor.
-
Adjust the position of the rubber seal (1) so that there is not excessive cable slack under the car.
-
Install the rubber seal in the hole.
-
Route the cable harness as shown in the illustration. Pull up the sill trim panel on the left-hand side and place the cable harness in the space along
the rear edge of the left-hand floor support. Make sure the cable harness is not pinched before reinstalling the sill trim panel.
-
Tighten the sill trim panel securely.
Illustration B
-
Secure the cable harness to the cable harness behind the battery with a tie strap (2) from the kit.
-
Connect the routed ground cable to the grounding point (3) behind the battery and tighten the grounding screw securely.
