volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Adapter 7 to 4 Pole Wiring For Towing|Page 16203 > < Adapter 7 to 4 Pole Wiring For Towing|Page 16201
Page 22
background image

-

Remove the rear roof panel covers and the screws beneath them.

-

Carefully pry off the panel at the rear edge. Use a plastic weatherstrip tool.

-

Pull the rear edge of the panel downwards until the four clips on the top release.

-

If the car is equipped with lighting in the panel, unplug the connector from the panel.

-

Pull the panel backwards to release it.

-

Carefully pull off the D-post panel. Start at the top edge then pull down until the three clips on the inside release. Do not damage the panel.

-

Disconnect the connector on the D-post panel (if the car has a loudspeaker in the D-post, the connector is in the loudspeaker).

-

Remove the panel by pulling upwards slightly and unhooking it from the side panel.

Illustration A shows the removal of the cover for the load securing eyelets 

-

Fold out the load securing eyelet.

-

Insert a scriber with an angled tip into the hole in the top of the cover.

-

Turn the scriber so that the angled tip engages in the reverse of the cover (1). Pull the cover off.

Illustration B applies to cars with two rows of seats

Adapter 7 to 4 Pole Wiring For Towing|Page 16203 > < Adapter 7 to 4 Pole Wiring For Towing|Page 16201