S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Route the cable harness from the tow bar connector through the hole in the floor.
-
Adjust the position of the rubber seal (1) so that there is not excessive cable slack under the car.
-
Install the rubber seal in the hole.
-
Route the cable harness as illustrated. Insert it through the hole along the rear edge of the left-hand cargo floor support.
-
Secure the cable harness to the cable harness behind the battery with tie straps (2) from the kit.
Illustration B
-
Connect the routed ground cable to the grounding point (3) behind the battery and tighten the grounding screw securely.
-
Connect the drain hose (4) to the battery.
Note! If the cable harness is stretched too tightly, it can scrape against the lower edge of the bumper and become damaged.
Make sure the cable harness curves around the lower edge of the bumper as shown in the illustration.
