S60 L5-2.4L VIN 64 B5244S6 (2003)
detaches completely
-
Place the bumper on a suitable underlay that will not damage the paint.
Remove:
-
the rivet (1) on the bracket (2) for the silencer. Use cutting nippers
-
the screws (3) on the bracket
-
the bracket by detaching the rubber mountings (4). The bracket will not be used again.
-
Remove the screws (1) and the bracket (2) from the rear of the car, right-hand side. The bracket will not be used again.
-
Install masking tape on the outside of the bumper to avoid damage from the saw.
Install masking tape opposite the cutting points and over the bumper cover
-
Leave the masking tape in place throughout the installation procedure
-
Cut along the markings for the cut out for the connection stud and the eyelets for the safety cable (see the inside of the bumper). Carry out the
operation so that the markings remain in the bumper afterwards
-
After cutting, smooth off the edges using a file.
Installing the detachable tow hitch (including the cable harness)
