S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Twist up the bracket with the trailer connector so that it is aligned straight and slightly away from the bumper.
-
Align the cable harness in the cut-out and secure the bracket.
-
Adjust the cable harness the whole way from the trailer connector and into the rubber grommet so that it does not hang under the car. Press the
excess cable length in through the rubber grommet.
-
Tighten the two tie straps (1) which were positioned earlier.
-
Cut a cut-out (1) in the location where the cable harness exits from the inside of the bumper on the left-hand side of the tow hitch, and enters the
rubber grommet in the floor.
-
Remove the protective paper (2) from the bumper.
Finishing work
-
Tighten the screw (1) on both sides.
-
Rivet (2) the bumper on the underneath on both sides as illustrated
-
Reinstall the nuts. Tighten the nuts to 18 Nm (14 lbf. ft.).
-
Install the rubber seals to cover the four nut holes
Reinstall:
-
the antenna connector
