S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Carefully drill out the rivet (2) at the bottom of the bumper on both sides. Use a 6 mm (13/32") diameter drill bit
-
Remove the screw (1) holding the liner for the bumper cover on both sides. Do not damage any of the plastic components.
Only applies if the car has clips:
-
Remove the clips (1) at the bottom of the bumper cover. First press in the centre of the clips until they click
-
Remove the clips.
Note! The clips will be reused.
Applies to all models:
-
Pull the bumper backwards slightly. Bend out the sides (2) so that they detach from the mounting (3). Then pull the bumper backwards until it
detaches completely
-
Place the bumper on a clean underlay that will not damage the paint.
Only applies if the car is equipped with mouldings:
-
Carefully remove the moulding (4) from the expander clips.
Illustration A
