S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Remove the screws (1) and the bracket (2) from the rear of the car, right-hand side. The bracket will not be used again.
-
Install masking tape on the outside of the bumper to avoid damage from the saw.
Install masking tape opposite the cutting points and over the bumper cover
-
Leave the masking tape in place throughout the installation procedure
-
Cut along the markings for the cut out for the connection stud and the eyelets for the safety cable (see the inside of the bumper). Carry out the
operation so that the markings remain in the bumper afterwards
-
After cutting, smooth off the edges using a file.
Installing the detachable tow hitch (including the cable harness)
-
Remove the tow hitch from the cross member. First turn the handle (1) clockwise until a click is heard and the pin (2) is in the outer position. Pull
the tow hitch straight back. Ensure that the shaft is greased.
