S60 L5-2.4L VIN 64 B5244S6 (2003)
Towbar US/CAN
NOTE: The ball holder and ball with the accompanying components are not included in the towing member kit and must be purchased as separate kits.
NOTE:
Kit contents:
1. Towing member
2. Screw M12x100 (x4)
3. Screw M12x50 (x2)
4. Washer (x4)
5. Washer 24x13x7
6. Washer, heat deflector plate
7. Screw (4.8 x 9.5 mm)
8. Seal (4x)
9. Blind rivet (x12)
10. Locking bolt (purchased separately)
11. Strap (purchased separately)
12. Ball holder (purchased separately)
13. Ball (purchased separately)
14. Nut M16 (purchased separately)
15. Locking washer (purchased separately)
16. Locking pin (purchased separately)
17. Protective cover (purchased separately).
18. Cover
Cargo compartment, preparations
-
Turn the ignition key to position 0 and remove the ignition key from the ignition switch.
NOTE: Wait at least five minutes before disassembling the connectors or removing other electrical equipment.
-
Install the cable harness connector for the towbar, according to the Installation Instructions for the appropriate cable harness.
-
Fold up the floor hatch.
-
Press the clips in the centre until a click is heard and then pull out the clips.
-
Remove the plastic nut.
-
Repeat the operation on the right-hand side.