S60 L5-2.4L VIN 64 B5244S6 (2003)
1. Loosely install the bumper. Make markings for the cut-out for the cable harness
2. Cut out as illustrated so that there is room for the cable harness.
Finishing work
-
If the mountings (1) have released from the rear edge of the wheel arch, reinstall the mountings.
Press the mountings completely back into their grooves and screw in the screw a few turns
-
Applies to cars with parking assistance: Lift up the bumper in position. Pull the cable for the sensors through the hole for the bumper's guide, and
pull the cable in from the inside.
-
Reinstall the bumper by pressing it forwards. Ensure that the four screws protruding from the bumper align with the holes in the car.
-
Before the bumper is completely installed, slide the top edge (2) into the grooves. Then slide the bumper fully in.
-
Tighten the screw (1) on both sides.
-
Secure both sides of the bumper with blind rivets (2) from below.
-
Reinstall the bumper's nuts. Tighten the nuts. Tighten to 18 Nm (14 lbf.ft.).
Reinstall:
-
The antenna connector
-
The mudflaps, if applicable
-
The rear wheels, tightening torque 140 Nm (103 lbf.ft.). Lower the car.
