S60 L5-2.4L VIN 64 B5244S6 (2003)
Remove
-
the lateral links from the sub-frame
-
the tie rods
-
the wheel spindle from the upper control arm
-
the anti-roll bar control arms from the upper control arm
-
the anti-roll bar from the sub-frame.
Installing the sub-frame
Install components on the sub-frame
Note: To ensure that there is no exhaust leakage, see: Flanged joint, assembling, refer to Exhaust System.
Install
-
the upper control arm.
-
the anti-roll bar on the new sub-frame. Tighten to 80 Nm.
Note: Lateral link, tie rod, lower control arm and wheel spindle are installed on the new sub-frame as one unit.
Install
-
the wheel spindle to the upper control arm. Do not tighten so hard that the toothed segment goes into the bushing on the wheel unit.