S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Hint: Make up two centering sleeves which are then placed on the rear mountings for the subframe. This will make it easier to center the rear
suspension. Measured at the centering sleeves A=20mm, B= 13mm, C=50mm.
Place the sub-frame on a lifting table.
-
Lift up the sub-frame enough to be able to install the EVAP canister. Tighten to 25 Nm
-
Lift the sub-frame up completely to the bodywork.
Release the lower control arms from the subframe.
Note: Ensure that the brake pipes are not crimped at the sub-frame mountings.
Install
-
the brake line mounting stays on the sub-frame bracket. Tighten to 25 Nm
-
the brake pipe in the clips on the sub-frame brackets.
