S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Install masking tape on the outside of the bumper to avoid damage from the saw
-
Leave the masking tape in place throughout the installation procedure
-
Cut out along inside of flange (1) on the underside of the bumper so that the flange stays in place in the bumper
-
Also cut out the shaded areas on both sides of the flange following the markings on the bumper
-
After cutting, smooth off the edges using a file.
Only applies if the car is equipped with mouldings:
-
Also cut out the moulding following the instructions (2).
Illustration B applies to the V70-R
-
Apply masking tape to the outside of the exhaust pipe cover to avoid damage from the saw. Leave the masking tape in place throughout the
installation procedure
-
Saw along the marked projection. Remove the cut out surface
-
After cutting, smooth off the edges using a file.
-
Remove the tow hitch. First turn the handle (1) to the right until a click is heard and the pin (2) is in the outer position. Pull the tow hitch straight
back. Ensure that the shaft is greased.