S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Tighten the screw (1) on both sides
-
Rivet (2) the bumper on the underneath on both sides
-
Reinstall the bumper nuts. Tighten the nuts. Tighten to 18 Nm (14 lbf.ft.).
Reinstall:
-
the antenna connector
-
the mudguards, if applicable
-
the rear wheels. Lower the car.
Install new rubber tabs over the four installed screws as follows:
-
Align the rubber tabs (1, 4) edge to edge with the lining mat
-
Compress the rubber tab (2) slightly to align in the cut out
-
Align the rubber tab (3) so that the lower edge is positioned edge to edge with the lining mat. Then cut off the section protruding from the lining
mat - do not remove too much
-
If necessary, cut away the area around the screw heads so that the screws are accessible.
Illustration A applies to installation of the tow hitch
-
Check the function of the detachable tow hitch.
