S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Clean away any underseal and dirt from the surfaces between the tow hitch and the bodywork.
Illustration B. Carry out this procedure on both sides. The right side is displayed
-
Install the screws (7, 8) from underneath the brackets (4:1, 5:1, 9:1), including the spacers (6). Tighten by hand. The arrows on the brackets (4:1,
5:1, 5:1) must point towards the centre of the car.
Illustration 10C
-
Install the heat deflector plate (14) with the screw (12). See point 10E.
Illustration 10E
-
Loosely screw the heat deflector plate into place on the member (2) using the screw (1)
-
Bend the heat deflector plate using a screwdriver
-
Fully screw in the screw.
Illustration 10C
-
Reinstall the rubber mounting (13) for the silencer. Use soap to facilitate installation.
Illustration 10D
-
Insert the member (1) between the brackets (4, 5). Centre it around the holes
-
Install the screws (2) and the washers (16) from the underside of the bracket (5). Install the nuts (3) from above the bracket. Do not tighten.
Illustration 10A
-
Check that the distance between the member (1) and the spare wheel well is 10 mm. Centre the tow hitch to the car.
Illustration B. Carry out this procedure on both sides. The right side is displayed
-
Tighten the screws (7). Tighten to 79 Nm (58 lbf.ft.)
-
Tighten the screws (8). Tighten to 120 Nm (88 lbf.ft.).
Illustration 10D
-
Tighten the screw (2) and nut (3). Tighten to 136 Nm (100 lbf.ft). Tighten on the right and left-hand side.
Illustration A and B
-
Wait at least five minutes, so that the joint has time to set. Then tighten the screws (8) on both sides, a quarter turn (angle tighten 90°).
Note! Torque tightened screws that have been removed must not be reused.
-
Underseal.
Applies to Sweden only
-
Carry out this operation only after the state road worthiness inspection.
