S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Install masking tape (1) on the outside of the bumper to avoid damage from the base of the saw.
Install masking tape opposite the cutting points and over the bumper cover, as illustrated.
-
Leave the masking tape in place throughout the installation procedure.
-
Cut along the marking on the inside of the bumper, as illustrated.
-
After cutting, smooth off the edges using a file.
Installation, fixed tow hitch (incl. cable harness)
Illustration A
-
Clean any underseal and dirt from the mating surfaces between the tow hitch end face and the bodywork.
-
Install the screws (2 and 4) from the underneath with the washers (5 and 13) between. Finger tighten.
-
Install a washer plate (6) on the left-hand side on the front screw (4). This is to secure the rear mounting for the heat deflector plate using the screw
(7). (See illustration B).
Illustration B
-
Install the heat deflector plate (1). Secure the heat deflector plate using the screw (7) for the washer plate (6).
-
Reinstall the rubber mounting (8) for the silencer.
