S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Install new rubber tabs over the four newly installed nuts as follows:
-
Align the rubber tabs (1, 4) edge to edge with the lining mat
-
Compress the rubber tab (2) slightly to align in the cut-out
-
Align the rubber tab (3) so that the lower edge is positioned edge to edge with the lining mat.
Then cut off the section protruding from the lining mat. Do not remove too much.
-
If necessary, cut away the area around the screw heads, so that the screws are accessible.
Securing the ball holder
NOTE: Ball holder and ball purchased separately.
-
Remove the cover from the towing member.
-
Insert the ball holder into the towing member until the holes in the ball holder and towing member correspond.
-
Slide the locking bolt into the hole.
-
Lock the other side using the locking pin.
-
Position the ball in the hole on the ball holder.
-
Install washer and nut, torque tighten to 244 Nm (176.5 lbf.ft).
Storing the ball holder
-
Remove the ball holder. Place the ball holder in the supplied storage bag.
-
Place the bag with the ball holder in the spare wheel. The ball holder must be positioned as illustrated.
-
Thread the strap through the two nearest holes in the wheel and around the ball holder.
-
Insert the strap into the tensioner. Tighten the strap until the ball holder is secured.
Installing the protective cover
