S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Mark out holes for drilling in the centre of the mounting pin for the clip. Use a small screwdriver or awl. Press straight through the side panel
-
Turn the panel around. Drill out the hole using a - 8 mm (5/16") drill.
-
Mark up for holes for the clip locating pin (1). First install the clip in the new hole (2) on the reverse of the side panel. Then press so that the
locating pin makes a mark (3) in the panel. Hold the clip parallel with the lower edge of the panel as illustrated
-
Make holes to align the locating pin. Use a small screwdriver or awl.
-
Press the clip into the two holes in the side panel
-
Lock the clip on the reverse using a locking washer from the kit. Use a counterhold when securing the locking washer
-
Press the end of the net in the clip with the rivets (1) for the elastic strap pointing inwards.
