S60 L5-2.4L VIN 64 B5244S6 (2003)
Brake Pipe Master Cylinder / ABS Unit, Replacing
Brake pipe master cylinder / ABS unit, replacing
Note! The method is almost the same for left and right-hand drive versions. On right-hand drive cars, the brake pipes are positioned between
the master cylinder and the ABS unit. They are clamped to the cowl in two places. All the illustrations in this section show the left-hand drive
version.
Preparation
Disconnect the battery lead
See Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting
Removing pipes
Collect the brake fluid
See Replacing the front brake calipers, B5244T5, B5254T2 See: Brake Caliper/Service and Repair/Removal and Replacement/Replacing the Front
Brake Calipers
Remove the plastic cap and the cable holder
Switch off the ignition.
Remove:
-
the plastic cap over the positive cable
-
the positive cable nut at the wheel arch. Fold the cable to one side
-
the screw on the clamp around the positive cable
-
the nuts on the cable holder.
Remove the air cleaner (ACL) housing