S60 L5-2.4L VIN 64 B5244S6 (2003)
left side of the sub-frame.Hang the passenger compartment heater from the bodywork.Remove the fuel line from the clips on the sub-frame and
the mounting by the steering shaft.
Preparations for removing sub-frame screws
Cars with turbocharged engines:Remove the charge air pipe from the hose connector at the lower connection for the charge air cooler (CAC).
Heat the charge air pipe when removing it.
Install the tools
Position mobile jack998 5972 JACK See: Tools and Equipment/998 5972 Jack under the left-hand side of the sub-frame.
Install 2 screws999 5517 SCREW LEFT See: Tools and Equipment/999 5517 Screw Left (bright) on the left hand-side, the front screw with a washer.
Install 2 screws999 5518 SCREW RIGHT See: Tools and Equipment/999 5518 Screw Right (yellow) on the right-hand side.
Tighten the tools so that they are in contact. Then tighten the nuts on the tools.
Remove the 2 screws from the support bracket by the rear sub-frame screw.
Move the mobile jack to the right-hand side and repeat the procedure.
Lower the sub-frame
