S60 L5-2.4L VIN 64 B5244S6 (2003)
Crankshaft Main Bearing: Specifications
Tightening Torque
Tightening the intermediate section
-
Install the two old screws for the flywheel and carrier plate at the rear edge of the crankshaft.
-
Lift these and the front of the crankshaft.
-
Carefully position the crankshaft in the block.
-
The crankshaft must not be turned before the intermediate section has been torque tightened. Position the intermediate section.
-
Lubricate and install all the screws.
NOTE: Use new M10 screws.
-
Install the intermediate section and the screws on the exhaust side at bearing recesses 2 and 5.
CAUTION: The M8-screws on the exhaust side are two different lengths.
-
Pull down the intermediate section.
Tighten the screws in the following order:
1. All M10 screws...................................................................................................................................................................................................20 Nm
2. All M10 screws...................................................................................................................................................................................................45 Nm
3. All M8 screws.....................................................................................................................................................................................................24 Nm
4. All M7 screws.....................................................................................................................................................................................................17 Nm
5. Angle-tighten all M10 screws.......................................................................................................................................................................90 degrees
Tighten the screws in sequence from the center and outwards.
