S60 L5-2.4L VIN 64 B5244S6 (2003)
Pull out the seal. Use puller 999 5919 PULLER See: Tools and Equipment/999 5919 Puller. Use emery cloth 951 1024 to clean the shaft journal and
mating surface.
Note! When cleaning work around the shaft journal, not in and out. It is essential that any residue from the emery cloth and any other
contaminants are completely removed before the new sealing ring is installed.
Lubricate the surface of the seal that the camshaft rotates against. Install the camshaft seal. Use drift 999 5450 PUNCH See: Tools and Equipment/999
5450 Punch.
Note! The seal is normally pressed in so that it is level with the internal bevelled edge.If the shaft journal is showing signs of wear, the seal can
be pressed in 2 mm deeper by turning the drift socket.
Installing components
Install:
-
the mixer. Tighten
-
the camshaft position (CMP) sensor and new cover. Tighten
-
the upper and lower engine stabilizer brace
-
the cover over the ignition coils
-
air cleaner (ACL) cover
-
the inlet hose between the air cleaner (ACL) and throttle body (TB)
