S60 L5-2.4L VIN 64 B5244S6 (2003)
Protect the reflectors/decor panel by taping over them with paper and masking tape.
Allow the adhesive to cool in the groove a bit so that it is easier to remove.
Cut the adhesive along both sides using tools 999 7067 Scrape See: Tools and Equipment/999 7067 Scrape and 999 7066 Filler See: Tools and
Equipment/999 7066 Filler until the surface in the groove is somewhat even. Even out any adhesive residue that is left using a hot air gun and chisel.
Lens installation, Bi-Xenon headlight
Fitting butyl tape
Remove the protective paper and masking tape from over the reflector/decor panel and light housing.
If necessary, carefully blow clean around the reflector and headlight housing.
Ensure that there are no lens pieces in the headlight housing.
Use: Butyl tape, 1161782
in the groove around the headlight, starting at the lower edge. Avoid touching the tape.
Installing the headlight lens
