S60 L5-2.4L VIN 64 B5244S6 (2003)
Install:
-
the trigger wheel
-
the camshaft position (CMP) sensor housing
-
the upper and lower engine stabilizer brace
-
the inlet hose between the air cleaner (ACL) and throttle body (TB)
-
the plastic nuts for the cover in wing liner
-
the wheel. See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair
-
the engine stabilizer brace. Tighten the screws at the suspension turrets and the screw for motor bracket. See Tightening torque See: Engine,
Cooling and Exhaust/Engine/Specifications/Mechanical Specifications/Tightening Torque
-
the cable to the battery negative terminal. First read Battery, disconnecting See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery, Disconnecting.
Test drive the car to check the function of the engine.
Removing the camshaft seal
The following components must be removed when replacing the rear camshaft seal:
-
the inlet hose between the air cleaner (ACL) and throttle body (TB)
-
place the air cleaner (ACL) cover to one side
-
the cover over the ignition coils
-
the upper and lower engine stabilizer brace
-
the camshaft position sensor (CMP) housing and trigger wheel.
Replacing the rear camshaft seal