S60 L5-2.4L VIN 64 B5244S6 (2003)
Communications Control Module: Pinout Values and Diagnostic Parameters
Connecting the Breakout Box
Connecting the breakout box, Audio control module
951 1507 Adapter 12-12-8-4-2 Pin See: Tools and Equipment/951 1507 Adapter 12-12-8-4-2 Pin
951 1428 Breakout box See: Tools and Equipment/951 1428 Breakout Box
951 1509 Adapter 13-8-6-8-2 Pin See: Tools and Equipment/951 1509 Adapter 13-8-6-8-2 Pin
Connecting the breakout box
Expose the head unit / audio module. See Radio cassette player, replacing See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Radio/Stereo/Service and Repair/Radio/Cassette Player, Replacing.
Check that the male and female terminals on the unit connectors are undamaged and secure (cannot be pressed in). Check that the cables to the female
terminals are secured to the terminal pins.
Note! In order for the below connections to be made take note of the color codes of the connectors.
Connect adapter951 1507 Adapter 12-12-8-4-2 Pin See: Tools and Equipment/951 1507 Adapter 12-12-8-4-2 Pin to the audio control module (wiring
side). Connect breakout box951 1428 Breakout box See: Tools and Equipment/951 1428 Breakout Box to the adapter.
Audio control moduleterminals:
#A1-#A12 correspond to terminals #15-#26 on the breakout box (green connector).
#B1-#B12 correspond to terminals #1-#12 on the breakout box (gray connector).
Terminals #E1-#E8 correspond to terminals #16-#23 on the breakout box.
When connecting connector D, adapter951 1509 Adapter 13-8-6-8-2 Pin See: Tools and Equipment/951 1509 Adapter 13-8-6-8-2 Pin must be used.
Terminals #D1-#D6 correspond to terminals #42-#47 on the breakout box.
The breakout box is designed to facilitate reading off the control module input and output signals when the control module is connected; and the cable
and component resistance when the control module is disconnected. The use of a breakout box reduces the risk of accidental short-circuited cables and
damage to the connector pins.
For further information about signals and other values, see Signal specification, audio control module See: Signal Specification.
Signal specification, audio control module
Connecting the breakout box and checking the ground terminal
Caution! Before starting to measure, the breakout box must be connected and the ground connections must be checked. See Checking the
ground terminals See: Component Tests and General Diagnostics/Checking Ground Terminal.
The audio control module, green connector