S60 L5-2.4L VIN 64 B5244S6 (2003)
Communication has been interrupted for one of the following reasons:
The ignition is switched off
VCT2000 disconnected from the data link connector (DLC)
VCT2000 disconnected from the VIDA cart
Communication problems in VIDA application or in car.
No voltage in the data link connector (DLC).
That the control module power supply and ground terminal are fault-free.
That the fuse for the data link connector (DLC) is intact.
that the ignition is on
that the battery voltage (system voltage) is normal (approximately 12 V).
If necessary a battery charger can be connected during the test.
For information about charge currents and the battery, see: Battery, charging See: Starting and Charging/Battery/Service Precautions/Technician Safety
that VCT2000 is correctly connected to the VIDA cart and the data link connector (DLC)
that VCT2000 and the wiring is fault-free.
For information about fuse and terminal numbers, see the relevant Wiring Diagram.
Try to establish communication again or exit reading off diagnostic trouble codes (DTCs). Depending on the communication fault, select one of the
1. Try again
2. Fault-trace more comprehensively for the communication problem that has occurred
3. Exit fault-tracing / Read off from the next system.
Which alternative is requested?
1 - digital display
2 - Checking communication fault
3 - FAILED
Checking communication fault
Checking communication errors
Selecting car model
Select car model to obtain relevant troubleshooting information.
Select one of the following model alternatives
1. Car model S40 (04-) / V50
2. Car model V70 (00-), V70 XC (01-) / XC70, S60, S80 and XC90
3. Car model V70 (-00), V70 XC and S70 / C70
4. Checking communication errors car model S40 (-04) / V40
Checking communication errors, car model S40 (04-) / V50
Hint: Test the communication with another corresponding vehicle to decide if the malfunction is in the vehicle or in VIDA/VCT/cable harness. If the
communication works on another vehicle, the malfunction is in the vehicle.
Hint: For current information about each circuit and signals, see wiring diagram and signal description for each system.