S60 L5-2.4L VIN 64 B5244S6 (2003)
Install 3 screws (torx 30). Tighten to 10 Nm.
Caution! It is important that the control module is securely mounted onto the bodywork if the sensor module is to operate properly.
Other components are reinstalled in reverse order.
Final check
Warning! The ignition may never be on when the SRS ignition cable connector is being removed or installed.
When all components have been installed:
-
switch ignition to position II
-
reconnect the battery negative lead.
Note! Check that the SRS indicator lamp is not defective by turning the key to position II. The SRS indicator lamp should light and go out after
approximately seven seconds.
