S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Tighten the screw (1) on both sides
-
Rivet (2) the bumper on the underneath on both sides as illustrated
-
Reinstall the bumper nuts. Tighten the nuts. Tighten to 18 Nm (14 lbf.ft)
-
Install the rubber seals to cover the four nut holes
-
Reinstall the antenna connector.
Installing the cable harness and control module
-
Clean the panel profile (1) under the right-hand tail lamp, where the Velcro strap is to be secured. Use a wet cloth and allow to dry. Position the
Velcro strap so that the control module is unimpeded by the hatch
-
Clean the corresponding surfaces on the reverse of the control module. Use a wet cloth. Allow to dry
-
Apply primer (P/N 9192679) to the cleaned surfaces. Allow to dry.
A. Remove the protective film from two of the Velcro straps of the same type.
B. Press the two Velcro straps into place on the reverse of the control module.
C. Press the two other Velcro straps onto the newly installed Velcro straps on the control module. Remove the protective film. Locate the control
module on the profile under the right hand tail lamp, as shown in the figure. Press the control module firmly into place.
-
Connect the cable harness with the 16-pin connector (from the kit) to the control module
-
Connect the cable harness for the sensors to the control module.
