S60 L5-2.4L VIN 64 B5244S6 (2003)
Lift the seat bracket. Install the active yaw control (AYC) sensor.
Install the 2 screws. M6
Connect the connector.
The right-hand screw for the seat bracket. M10
The 2 front screws for the seat rails. M10
Audio module (AUD).
Calibrate as follows: VIDA\ vehicle communication\ brakes\ calibrating.
Turn on the ignition.
The symbol on the dashboard must go out within 5 seconds.
In the event of a fault the symbol is on continuously.
Test drive the car after repair. See Test Drive Form (DSTC (dynamic stability and traction control) /brake control module), description See: Brakes and
Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Drive Form
(DSTC (Dynamic Stability And Traction Control) /Brake Control Module), Description.