S60 L5-2.4L VIN 64 B5244S6 (2003)
Fuel gauge sensor
Position level sensor correctly
Install a new rubber seal
Connect the 2 connectors to the level sensor
Press tube system onto level sensor
Carefully position level sensor down with tube system and wires
Install level sensor attaching ring but do not tighten it
Press level sensor into position. Note position marks on cover and tank
Tighten lock ring, first by hand and then using special tool 999 5720 Wrench See: Tools and Equipment/999 5720 Wrench
Install wire in rubber seal slots
Connect the connector
Install level sensor cover
The rest of the section is done in reverse order.
To replace fuel gauge sensor on right side, see Right side fuel pump with level sensor See: Right Side Fuel Pump With Level Sensor.
Level Sensor, Fuel Tank Left, Replacing
Level sensor fuel tank left, replacing
999 5720 Wrench See: Tools and Equipment/999 5720 Wrench
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Disconnecting the battery lead
Disconnect the battery negative lead. See: Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Warning! Explosion risk.Use a fresh air mask.
Draining fuel tank
Note! Before draining the fuel, see: Safety regulations for handling fuel See: Powertrain Management/Fuel Delivery and Air Induction/Service
Precautions/Safety Regulations for Handling Fuel.
Insert the heavy duty hose 1.3 meters into the fuel filler pipe, measured from the edge of the opening of the filler pipe.
Pump until air comes out.
V70: Fold up both sides of the rear seat. Remove the rear seat.
S80, S60: Remove the seat cushion for the rear seat.
Removing the insulation panel