volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 1
background image

Crankshaft Position Sensor: Service and Repair

Engine speed (RPM) sensor, replacing

Removing the engine speed (RPM) sensor

Remove the pipe between the front cover plate and the air cleaner (ACL).
Disconnect the hose between the air cleaner (ACL) and the throttle body (TB). Put the hose to one side.
Remove the throttle body (TB).
Clean the gasket face.
Expose the wiring.
Disconnect the connectors.
Remove the sensor.

Installing the engine speed (RPM) sensor

Connect the connector.

Install

-

the sensor. Tighten to 10 Nm

-

wiring

-

the throttle body (TB) with a new gasket. Tighten to 10 Nm

-

the hose between the throttle body (TB) and the air cleaner

-

the pipe between the front cover plate and the air cleaner (ACL) housing.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Crankshaft Position Sensor > Component Information > Specifications > Page 2122

< PREV PAGE NEXT PAGE >