S60 L5-2.4L VIN 64 B5244S6 (2003)
Install
-
Adjust the position of the wheel spindle and spring strut.
Tighten the wheel spindle to the spring strut. Tighten to 105 Nm. Angle tighten to 90°. Use bevel protractor 951 2050
-
the anti-roll bar link to the spring strut. Use a new nut. Tighten to 50 Nm. Counterhold with a Torx wrench so that the boot is not damaged
-
the ABS sensor cable
-
ABS sensor onto the wheel spindle. Tighten the ABS sensor. Tighten to 10 Nm.
Note: Ensure that the sensor seat in the wheel spindle is completely clean. Clean the ABS sensor with a soft brush.
-
the brake disc. Tighten the brake disc locating pin. Tighten to 8 Nm.
Note: Ensure that the brake disc and wheel rim hub mating surfaces are clean.
Tighten the drive shaft screw. See Tightening torque. Use a screwdriver as a counterhold on the brake disc.
-
the brake caliper and the limiter. Use new screws. Tighten to 100 Nm
-
the wheel.