S60 L5-2.4L VIN 64 B5244S6 (2003)
Align puller 999 7062 Separator See: Tools and Equipment/999 7062 Separator with the link arm and nut 999 7231 Nut See: Tools and Equipment/999
7231 Nut.
Tighten the puller 999 7062 Separator See: Tools and Equipment/999 7062 Separator so that the ball joint releases from the link arm.
Applies to all
Caution! Do not pull the drive shaft as the axial pinions cannot support large loads.
Note! If the hook is positioned at point (2) there is a risk of damaging the rubber boot on the ball joint.
Press the control arm down using lever 999 7076 Lever See: Tools and Equipment/999 7076 Lever. Position the hook at (1).
Release the spring strut from the control arm.
Removing the ball joint screws