S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Note: Use new screws for the sub-frame mountings.
-
Slide up the centering sleeves in the two rear mountings on the sub-frame
-
Install the screw. Tighten lightly
-
Install the screws for the front mountings on the sub-frame. Install the screws through the brackets
-
Install the screw for the brackets
-
Tighten all the front mountings. Tighten to 80 Nm
-
Remove the screw for the rear mountings on the sub-frame. Remove the centering sleeves
-
Install the screws for the rear mountings on the sub-frame. Tighten to 80 Nm
-
Install the fuel filter and holder on the right bracket. Tighten to 25 Nm.
Remove the lifting table.
Finishing
-
Pop rivet the heat deflector for the exhaust pipe into the left rear mounting on the sub-frame
-
Install the fender liner. Tighten the fender liner with the plastic nut.
Detach the lower control arm from the sub-frame.
Bend the lower control arm down to install the spring and shock absorber.